Air Hammer Chisel Set
Air Hammer Chisel Set
Check out this page if you are looking for Air Hammer Chisel Set
 |
 9 Piece Air Hammer Chisel Sets 401 and 10mm shank 4 lots  US $62.95
|
 9 Piece Air Hammer Chisel Sets 401 and 10mm shank 2 lots US $37.75
|
 JET JSG 1304 Air Hammer Chisel Set 4 Piece US $27.71
|
 9 pc Air HAMMER Chisel SET US $29.99
|
 Ingersoll Rand 115K Air Hammer Tool W Chisel Accessory Set IR115K US $59.99
|
 Ingersoll Rand Air Hammer and Chisel Set 114GQC US $59.99
|
 NEW JET TOOLS 4pc AIR HAMMER CHISEL SET JSG 1304 US $24.99
|
 New 190MM Air Hammer Chisel Set Air Tool Automotive Home Applications 3000BPM US $19.25
|
How to Remove Ball joint Rivets?
Trying to change lower ball joints in a 96 sunfire. How the hell do you get the rivets out? I have a air hammer and a chisel set, and a air grinder. Can I just grind off the head of the rivet and use the air hammer to push the rivet out. Do i need to remove castle nut and the ball joint stud from knuckle first or will they come out while still attached? Any help would be great cause I'm at the end of my rope with this job.
p.s. I tried to drill them out but i cant get a drill under the ball joint and enough up pressure to drill them out.
ya, you cannot drill through rivets, the way you are supposed to do it is to use either a air die grinder or a dremel tool to grind one side of the rivets flush with the control arm, then take a center punch and a hammer and knock the remaining part of the rivet through. it should hammer out with no problem, if you have any question just e mail me gixxerscum@yahoo.com